EUROMAP 70 Electrical Interface between Injection Moulding Views. 6 years ago. Euromap, · Electrical, · Interface, · Injection, · Moulding. Euromap 2: Mould Fixing Dimension for Injection Moulding Machines. Specific information .. Mechanical properties, , Mechanical restraints, The electric control M2C is used for large machines. – highest safety standards ( as per EN /EN ) – standardised integration via EUROMAP 70 interface.
|Published (Last):||15 April 2008|
|PDF File Size:||3.6 Mb|
|ePub File Size:||15.15 Mb|
|Price:||Free* [*Free Regsitration Required]|
Quick die change on presses and automatic punching machines. Pin a2 and Table 2: Figure 12 Magnet clamping system for an injection moulding machine of the company Ferromatic Closure force: There are no limits set to the geometric shape of the magnetic plates.
Magnetic clamping systems for deformation tools
Rotary table with magnetic plate. Figure 9 Long pole technology in a to injection moulding machine Closure force: A permanent monitoring of the clamping condition, the temperature, and the position of the die by a supplied, separate control offers the maximum possible safety for automated processes.
In operation, the system works independently of any power supply.
The system consists of two electro-permanent magnetic plates, a control, a remote control, a complete set of cables and mounting takes often only a few hours. Products Service Support Duromap Company.
The electric control M1C is used for small and medium-sized machines. Eruomap is suitable for fitting or retrofitting without any problems in nearly all presses.
The design of the magnetic plates is very flexible and can be adapted in size and shape for different requirements according to the user’s specification.
M-TECS function principle for vertical design. An indicator light on the remote control continuously shows the state of the system.
Figure 8 Magnet clamping system for an injection moulding machine of the company Engel Closure force: All signals except table 1: The mains supply of the MCS is also specified. The product range “M-TECS” stands for magnetic clamping technology, that means clamping technology of the highest level and offers the following key advantages for the user: All of the desired performance levels can be met.
Figure 10 Magnetic clamping system installed in Arburg C High concentration effect of the magnetic force close to the centring ring. A supplied separate control in combination with the press control provides the required safety for man and machine.
Also very small moulds are safely clamped. For easy and safe mould change, roller bars with spring packs are installed below the magnetic plate. Magnetic clamping system for a KM Magnetic clamping systems especially designed for mould carrier machines.
Figures 1 and 2 corrected v. Figure 14 Magnetic clamping system for a vertical Arburg machine With double rotary table Clamping plate at the top and at the bottom. In addition recommendations are given for signal voltage and current levels. Control and signal exchange with requirements for high performance levels. Plug on the injection moulding machine male.
EUROMAP 70 – version 1.5
This is intended to provide interchangeability. The interface to the press is always designed redundantly, is effected via potential-free contacts to stop or drive the machine.
M-TECS square poles for extremely heavy machining Each magnetic plate can be individually adapted to the particular machine table. Combinations with Hilma machine vices or Stark zero point clamping systems can be easily realised, as they all come from a single supplier.